Engineering Expertise
Go to Manufacturing
Capabilities Page
Quality
and innovation go into the building of each ECOLAIRE condenser... on
the CAD/CAM design system, on the assembly floor, in the test
lab, and at your jobsite. The result is a condenser specifically
engineered to meet the needs of your application... and built to
perform at full design efficiency.
ECOLAIRE condensers
have a worldwide reputation for efficient performance and long
life. We start by designing each condenser on an individual basis,
to meet the specifications for your system. Our engineering staff
considers every element that will affect condenser efficiency
over your specified plant operating range to offer you the best
possible heat rate over the widest range.
Based on
the system data you provide, we engineer a condenser to meet your
specific site requirements. We design and build it to Heat Exchange
Institute Standards with attention to every detail. Service connections
are designed for both static and dynamic reactions and to cope
with potential erosion. We give the same attention to these connections
as to the unit itself because we believe a service connection
malfunction should never be the cause of a condenser's being taken
off-line.
 ECOLAIRE's
CAD capabilities range from two dimensional drawings with direct
computer interface for bill of materials generation to three dimensional
parametrically driven models of components and assemblies. The
system yields more standardization, quick response to customer
needs, lower levels of rework or revisions, and higher field fit-up
reliability. The CAD system is integrated from marketing through
manufacturing.
|
